Why Does Metal Expand When Heated?
Heat makes the atoms in a metal vibrate harder, and because of how atomic bonds work they drift slightly apart. Here is why metal grows, by how much, and why it matters.
A stuck metal lid on a glass jar often comes loose after a minute under hot water. Railway lines are watched closely on summer afternoons, and long bridges have toothed gaps in the road surface that open and close with the seasons. All of these come from one quiet fact: metal grows when it gets warmer and shrinks when it cools.
The change is tiny for any single object, usually a small fraction of a millimetre per metre for an ordinary rise in temperature. But engineers have to plan for it, because a growing rail or beam that has nowhere to go pushes on whatever is holding it. Understanding why it happens also explains why some materials barely expand at all.
The short answer
- The atoms in a solid metal are constantly vibrating about their positions. Heating makes those vibrations larger.
- The force between neighbouring atoms is lopsided: it resists being squeezed together far more strongly than it resists being pulled apart. As vibrations grow, the atoms spend more time further apart, so the average spacing increases.
- For most purposes the growth is proportional to the temperature change:
ΔL = αLΔT, where α is the material’s expansion coefficient. - If expansion is blocked, it turns into large forces, which is why rails, bridges and pipes need room to move.
The basic principle: atoms that vibrate in a lopsided well
A metal is a regular arrangement of atoms held together by bonds. It helps to picture each atom sitting in a hollow, or energy well, created by the attraction and repulsion of its neighbours. At its lowest energy the atom would sit at the bottom of that hollow, at a fixed distance from the atoms around it.
At any real temperature, though, atoms are never still. They vibrate back and forth around their resting positions, and the hotter the metal, the more energetic the vibrations. If the hollow were perfectly symmetrical, like a bowl, an atom would swing equally far in both directions and its average position would not change, however hard it vibrated.
The hollow is not symmetrical. Pushing two atoms closer together quickly runs into strong repulsion between their electron clouds, so that side of the well is very steep. Pulling them apart is resisted by a gentler attraction, so that side slopes away more gradually. When an atom vibrates with more energy, it can travel further outwards than inwards before turning back, and its average distance from its neighbours creeps up. Physicists call this lopsidedness anharmonicity. Multiply that small shift across billions of atoms in a row and the whole object becomes measurably longer.
How it works, step by step
- Heat is supplied, for example by sunlight on a rail or hot water on a jar lid.
- The atoms gain vibrational energy and swing further from their resting positions.
- The asymmetric bond lets them move further apart than together, so the average spacing between neighbouring atoms increases slightly.
- Every bond in the object lengthens a little, so length, width and thickness all increase together.
- If the object is free, it simply gets bigger. If it is held in place, the blocked expansion becomes compressive stress, which can make it bend or buckle.
- On cooling, the vibrations shrink and the object returns to its original size, provided it was not permanently deformed along the way.
The science behind it
The expansion equation
Over ordinary temperature ranges, the change in length of a solid is well described by:
ΔL = α × L × ΔT
where ΔL is the change in length, L is the original length, ΔT is the change in temperature and α (alpha) is the coefficient of linear expansion, a property of the material. Because an object grows in every direction, its volume grows roughly three times as fast as its length, so the volume coefficient is approximately 3α.
How much do different materials expand?
The table below shows typical linear expansion coefficients at 20 °C, expressed in millionths of the length per degree Celsius (10−6/°C), together with an approximate calculation of how much a 1 m bar of each would grow if warmed by 50 °C.
| Material | α (×10−6 per °C) | Approximate growth of a 1 m bar warmed by 50 °C |
|---|---|---|
| Aluminium | 24 | 1.2 mm |
| Brass | 19 | 0.95 mm |
| Silver | 18 | 0.9 mm |
| Copper | 17 | 0.85 mm |
| Gold | 14 | 0.7 mm |
| Steel | 13 | 0.65 mm |
| Iron | 12 | 0.6 mm |
| Ordinary glass | 9 | 0.45 mm |
| Borosilicate (Pyrex) glass | 4 | 0.2 mm |
| Fused quartz | 0.59 | about 0.03 mm |
Aluminium grows nearly twice as much as steel for the same temperature change, which matters whenever the two are joined. It also explains the jar-lid trick: a metal lid expands more than the glass rim beneath it, so warming both loosens the grip slightly.
Worked examples (approximate)
A railway rail. A 100 m length of steel rail warming by 30 °C would, if free, lengthen by about 13 × 10−6 × 100 m × 30 ≈ 0.039 m, or 39 mm.
A large bridge. A widely used university physics textbook works through the steel main span of the Golden Gate Bridge, 1,275 m long. Between −15 °C and 40 °C, its length changes by roughly 0.84 m, which expansion joints must accommodate.
A fuel tank. The same textbook shows that a 60-litre steel tank filled to the brim with petrol at 15 °C will overflow by about 1.1 litres when both warm to 35 °C, because the liquid expands much more than the steel container.
When expansion is blocked: thermal stress
If a bar is fixed at both ends and then heated, it cannot lengthen, so the material is compressed instead. The stress that builds up is approximately:
stress = Y × α × ΔT
where Y is Young’s modulus, the material’s stiffness. Because metals are stiff, even a modest temperature rise can produce a large force on whatever is restraining them. That is the basic reason long, constrained structures either have expansion gaps or are designed to carry the force safely.
Real-world applications
Railways. Network Rail notes that rails in direct sunlight can be up to 20 °C hotter than the surrounding air, that most of its network can run with track temperatures up to 46 °C, and that rails have been recorded at 51 °C. Rails are stressed during installation to set the temperature range they can cope with; setting them for very hot days would make them less resilient in winter, so the choice is a compromise. Painting rails white can keep them 5–10 °C cooler, and when monitoring suggests track is expanding too much, speed restrictions reduce the forces trains put on it. Older short, bolted rails have small gaps between lengths to allow for expansion.
Bridges and buildings. Expansion joints, the interlocking plates you drive over on many bridges, let decks grow and shrink without pushing on their supports.
Thermostats. A bimetallic strip bonds two metals that expand by different amounts, such as brass and steel. When heated, the brass side grows more, so the strip curls. Coiled into a spiral, this movement has long been used to open and close the electrical contacts in traditional heating thermostats.
Precision instruments. Some jobs need a metal that barely expands. The physicist Charles-Édouard Guillaume found that certain nickel–iron alloys have an unusually low expansion coefficient. The best known, Invar, was quickly adopted for surveying baselines, astronomical clock pendulums and precision instruments, and the discovery earned him the 1920 Nobel Prize in Physics.
Thermal expansion is one of several ways metals respond to heat; for how they move heat, see our article on why metal feels colder than wood.
Common misconceptions
The atoms themselves get bigger
The atoms do not swell. What changes is the average distance between them, because their larger vibrations are lopsided.
A hole in a metal plate shrinks when the plate is heated
Every dimension of a uniformly heated plate grows in proportion, including the distance across a hole. The hole gets slightly larger, exactly as if it were made of the same metal. This is why heating a tight metal ring can help it slip over a shaft.
Everything expands when heated
Most materials do, but not all, and not at every temperature. Liquid water contracts as it warms from 0 °C to about 4 °C, and some specially engineered ceramics, such as zirconium tungstate, shrink when heated over a wide range of temperatures because of the way their atomic frameworks flex.
Limitations and exceptions
The simple equation assumes α stays constant, which is a good approximation over everyday temperature ranges but becomes less accurate over very large ones. Some crystals expand differently along different directions, and graphite even contracts in some directions over certain temperatures. Alloys can behave very differently from the metals they are made from, as Invar shows.
Expansion is also only part of the story at high temperatures, where metals soften, oxidise or change their internal structure. Where heat meets confinement, the forces involved can be dangerous: never heat a sealed metal container, and for structural, pressure or pipework problems involving temperature changes, consult a qualified engineer.
Frequently asked questions
Why does running hot water over a jar lid help open it?
The metal lid expands more than the glass jar for the same temperature rise, so the lid grows slightly away from the glass and the grip loosens.
Do railway tracks really bend in hot weather?
They can. If a rail gets hotter than the range it was set up for, the compressive force can make it buckle sideways. Rail operators reduce the risk with stressing, white paint, monitoring and speed restrictions.
Which common metal expands the most?
Of the everyday metals in the table above, aluminium expands the most, at about 24 millionths of its length per degree Celsius, roughly twice as much as steel.
Is there a metal that does not expand at all?
No common metal has zero expansion, but nickel–iron alloys such as Invar expand very little near room temperature, which makes them valuable for precision instruments.
References
- Ling, S.J., Moebs, W. and Sanny, J. OpenStax. University Physics Volume 2, 1.3 Thermal Expansion.
- HyperPhysics, Georgia State University. Thermal Expansion Coefficients at 20 C.
- Oliver, M. and Cranford, S. Laboratory of Atomistic and Molecular Mechanics, MIT. Thermal Expansion.
- Barrera, G.D., Bruno, J.A.O., Barron, T.H.K. and Allan, N.L. Negative thermal expansion. Journal of Physics: Condensed Matter, 17, 2005.
- Network Rail. Buckled rail and summer heat.
- University of California, Santa Barbara, Physics Lecture Demonstrations. Bimetallic strip.
- The Nobel Prize. Charles Edouard Guillaume: Biographical.
Header photo: Jake Weirick on Unsplash.